• Your shopping cart is empty!

CXRacing LS1/LSx Engine Headers For 91-99 BMW E36 Swap

Application:
Chassis: 91-99 BMW E36
Motor: LS1/LSx

Product Being Sold:
Headers Only

This is CXRacing's Newest Products for BMW E36 Chassis. All Parts are Developed from Ground Up, Designed and Built Specially for the E36 Chassis with LS1 Motor Swap. It is one of the Best Complete Kits Available with the Most Competitive Cost. Kit is Bolt on Fit and Easy Install.

Product Info and Spec:

This Kit Comes with Many Innovative Designs:
Equal Length Runners for Best Performance Gain
Long Tube Design for More Power and Torque
1.65" OD Stainless Steel Mandrel Bent Tube Runner
3" Vband Ends for Easy Adaptation of the Rest Exhaust System

Note:

This kit is for a Pair of Headers ONLY. Headers Fit CXRacing's LS1 Swap Kit Perfectly. If Using Other Mounts, Header Might Hit other Parts. We do offer Complete Kit, Please Check Our Other Products

This Product was developed based on US model Left-Hand-Drive chassis. For Right-Hand-Drive, due to potential conflict with steering shaft, fitment most likely will be an issue and we don’t guarantee fitment. Modification is needed and we won’t accept return due to Right-Hand-Drive fitment issues.
　 　 　 　 　 　 　 　 　 　 　 　

Write a review

Please login or register to review

LS1 LSx LS Header Headers For BMW E36 Swap

  • Brand: CXRacing
  • Product Code: HD-LS1-E36
  • Availability: In Stock

  • $830.00


0 reviews / Write a review

Tags: CXRacing LS1/LSx Engine Headers For 91-99 BMW E36 Swap Application: Chassis: 91-99 BMW E36 Motor: LS1/LSx Product Being Sold: Headers Only This is CXRacing's Newest Products for BMW E36 Chassis. All Parts are Developed from Ground Up, Designed and Built Specially for the E36 Chassis with LS1 Motor Swap. It is one of the Best Complete Kits Available with the Most Competitive Cost. Kit is Bolt on Fit and Easy Install. Product Info and Spec: This Kit Comes with Many Innovative Designs: Equal Length Runners for Best Performance Gain Long Tube Design for More Power and Torque 1.65" OD Stainless Steel Mandrel Bent Tube Runner 3" Vband Ends for Easy Adaptation of the Rest Exhaust System



Emission Notes:

All Parts and services offered by CX-GARAGE are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CX-GARAGE assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CX-GARAGE products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.