CXRacing Turbo Header Downpipe Kit For 1st Generation 99-07 Chevrolet Silverado (GMT 800 Platform) with Vortec V8.

Fits 2WD ONLY, Does NOT Fit AWD (Cross Pipe Hits Driveshaft)

This Is A Solid Proven Kit, Perfect Fitment. We Developed This Kit From Scratch, Fully Tested, See Installed Pictures On and Outside the Car.

Perfect Fitment. Keeps All Stock Parts and Accessories. No Cut, No Relocation (Except MAF Sensor Wires Need to Be Cut and Extended).

Single Big T4 Turbo Provision, Supports 700-800 WHP.

60mm Vband WG and 50mm BOV Provision.

2.5" Cross Pipe, Excellent Ground Clearance. Above Oil Pan Level.

3" Turbo Downpipe then Enlarged to 3.5" Exhaust Pipe

Much Better Response Compare to Rear Mount Turbo Setup.

We Developed and Tested This Kit Based on a 4.8L Motor with a T76 Turbo, Makes 335 WHP at Low Boost of 12 PSI, with 40lbs Injectors and Pump Gas. Considering the Power Lost from Crank to Wheel, Our Test Setup Makes Around 420-445 HP (vs 270-280 HP Stock Power)

For Larger Vortec V8 (5.3L, 6.0L) with Built Motor and Larger Turbo, This Kit Supports 700-800 WHP.

Note:
We Offer Different Combinations Of This Turbo Kit. The One Being Sold Is Header, Cross Pipe, and Downpipe Hardware Kit ONLY.
Turbo, WG, BOV, Intercooler Kit Are NOT Included. Check Our Other Products for Different Offerings.

Exhaust Pipe Is 3.5 Straight Pipe, It Does NOT Have Flange Welded, You Will Need To Fabricate the Rest of the Exhaust System.

No Instillation Instruction Is Provided. But We Show Many Installed Pictures, It Is Very Intuitive.

Application:
Chassis: 99-07 Chevrolet Silverado
Motor: LM, LQ Vortect V8

Note:
This Kit Is Developed Based on A 2002 Silverado, It Should Fit Other GMT800 Platform Vehicles.

Product Being Sold:
Turbo Headers + Cross Pipe + Downpipe + WG Dump pipe + Vband Clamps

This is CXRacing's Newest Products for the Application Stated Above. All Parts Are Developed from Ground Up in Our R&D Center in USA, Designed and Built for Improved Performance Gains, with Excellent Fitment and Easy Installation.

This Product was developed based on US model Left-Hand-Drive chassis. For Right-Hand-Drive, due to potential conflict with steering shaft, fitment most likely will be an issue and we don't guarantee fitment. Modification is needed and we won't accept return due to Right-Hand-Drive fitment issues.

Product Info and Spec:
Manifold:
CXracing's Proprietary Design, Keeps All Stock Parts and Accessories
Stainless Steel 1.65" Runner Tube
Works With CXRacing's T4 Turbo Elbow Adapter. Flexible Fitment For Many Turbos
60mm Vband Wastegate Provision
2.5" Cross Pipe with Vband Connections
Comes with 60mm WG Dump Tube

Downpipe:
2 pcs 3" Downpipe Connects to Turbo (Fits Turbo with 3" Vband Exhaust Outlet)
3.5" Straight Exhaust Pipe

Notes:

Off Road or Track Use ONLY, NOT for Street Use

Due to the Complexity of Converting a Motor from NA to Turbo, Please Make Sure that You Understand the Application Stated Here are the Right Parts for Your Project

Parts Being Sold are the Kit Being Advertised ONLY. Other Parts Shown on Pictures are for Demo Only .